Avoid Having to Jump Start Your Car
Ever tried to jump start your car battery and was dismayed that it was covered in gunk? That nasty gunk is usually battery oxidation that is formed by acid condensation. It might be cleaned using a basic chemical solution, since it has been formed by an acid. Should you have baking soda at home, then you’ll be able to remove the battery acid. You need to be careful when doing it but there are just a few instructions on how to clean your battery.
First off, you’ll want the tools which you can locate easily in the house. You mainly need safety glasses for your eyes, baking soda, adaptable pliers and screwdrivers with insulated handles and a stiff-bristled brush. A few open-end and box wrenches, a plastic or metallic scraper, cleaning brushes for a battery terminal, and a turkey baster or maybe small funnel. You should also have a number of sponges, spray-type household cleaner, rubber gloves and a bucket of clean water. This might seem like a lot of things for cleaning a battery, but we did mention doing it safely.
Battery Cleaning Ingredients
A few of the corrosive build up have sulfuric acid, so it is a wise idea to use the safety glasses to protect your eyes, and the rubber gloves for your hands. You’ll want to keep this compound away from your car, since it can eat away the paint. Depending on how corroded the battery is, the amount of cleaning that is needed will vary. It is possible, to get every last bit of dirt and corrosion off of the battery, that the battery will need to be taken out of the vehicle. The first step is to utilize the scraper to remove as much dirt as possible and use the bristle brush to get at more.
The next thing to perform will be to mix one tablespoon of baking soda with one pint of water then use it to clean the battery and the cable connections using the turkey baster. Then you’re able to use the bristle brush so that you can loosen and remove the debris from the battery and you want to remove the cables so that cleaning will be easier. When disconnecting the electric battery, be sure to use the pliers or wrenches to loosen the connection and take them off with negative first then positive. Brush off every last bit of oxidation from the terminals and all of the parts, and then flush each one with the baking soda solution.
So now apply the liquid cleaner in the spray bottle, and a sponge to get rid of the remaining dirt and grease. Immediately after, dry every one of the parts and reassemble everything and be sure you refasten the cable with positive first. Lastly, be sure that everything is attached and now you have a clean and safe battery.